Two novel memory polynomial models are derived based on physical knowledge of a general power amplifier (PA). The derivations are given in detail to facilitate derivations of other model structures. The model error in terms of normalized mean square error (NMSE) and adjacent channel error power ratio (ACEPR) of the novel model structures are compared to that of established models based on the numb

The design and fabrication of a wide-band programmable radio frequency (RF) feed network is proposed. It is designed to cover a wide band from 2.5 to 6 GHz over two separate branches. The feed network is simulated and fabricated on an FR-4 substrate with 0.8 mm thickness. Good matching between simulation and measurement results is achieved. The measured amplitude resolution was 0.5 dB with a maxim

In the present study, an ultra-wideband (UWB) antenna has been proposed using coplanar waveguide (CPW) feed with dual-band-notch characteristics. Slot-loaded radiator and U-shaped CPW resonator are used for band rejection at 3.5 and 5?6 GHz respectively to reduce interference with existing World interoperability for microwave access and wireless local area network systems. With an extended operati

In this paper, staircase-shaped ultra-wideband (UWB) response is proposed. UWB technology being emerging technology of decade needs development of antennas with small size. This paper proposed the design of antennas for UWB technology with small overall size. The feed used in the proposed design is microstrip feed line. The defected ground structure and staircase patch have been used to enhance ba

In the field of high data rate wireless communications, localization issues play a key role in achieving energy-efficient communication and geographic routing. time-difference of arrival (TDOA)-based localization methods present numerous advantages. In this paper, a new method of TDOA estimation is proposed. With this method, unlike conventional TDOA measurements, it is possible to perform communi

A simple and volume efficient circular antenna-array design with a low profile programmable beam rotation mechanism was presented. The proper selections of the rotation vector and the excitation coefficients of rectangular array-elements were made for rotation of the beam. The proposed rotation mechanism was capable to rotate the radiation pattern at any desired speed and to transmit in any desire

This paper presents a very flexible tool for numerically evaluating the small-signal and noise parameters of a transmission line subject to an arbitrary thermal gradient. Contrary to previous methods, the proposed approach allows straightforwardly taking into account possible variations of electrical parameters along the propagation direction, such as may be expected when temperature ranges betwee

In this paper, we present a near-field microwave microscopy method for the characterization of dielectric materials samples in the Industrial, Scientific and Medical (ISM) band. The system proposed is composed of a probe coupled to a dielectric resonator (DR) operating in the TE mode. Latter this is used to fix the resonance frequency of the resonator at 2.45 GHz. This system is used for the chara

In this paper, design, manufacture, and measurement of a wideband matching network for a broadband V-shaped square planar monopole antenna (V-SPMA) is presented. Matching network design is unavoidable in most cases even vital to facilitate a maximally flat power transfer gain for an antenna. In the work, a bandpass matching network (BPMN) design is done for a particular square monopole antenna wit

In this paper, a low-power CMOS LC voltage-controlled oscillator (VCO) with body-biasing and low-phase noise with Q-enhancement techniques is presented. A self-body biased circuit is introduced that can reduce power consumption. Some derivations of the Q-enhancement and how to improve the phase noise of the circuit are also discussed. This chip is implemented by the Taiwan Semiconductor Manufactur

A comparative analysis of radiated power in relativistic magnetron is done using particle-in-cell simulations performed on Magic3d code developed by ATK Mission Systems. The Resonator with dielectric side-walls (DSW) is compared with no-side wall (NSW) configuration having same input parameters and resonator dimensions. Observations and comments have been made on the output power, obtained both ax

An optoelectronic oscillator (OEO) under the influence of a weak interference has been investigated. The system equation of the OEO under the influence of interference has been derived. A novel technique for calculating the lock range of the oscillator using the harmonic balance method in presence of interference has been demonstrated. Theoretical analysis coupled with experimental results has bee

Three-dimensional compact volume internal antenna for universal serial bus (USB) dongle that covers hexa operating bands is proposed in this paper. The volume of the proposed USB dongle is 15×20×4 mm; it is based on two connected monopoles, one of them is semi-circular monopole ended by three unit cells of meander-line and the other is a bent monopole with four unit cells of high-impedance wire. T

The paper proposes a new design for a single-arm, rectangular, spiral antenna (SARSA) with a wide azimuth space coverage. The antenna, operating at around 3.3 GHz, is capable of steering the beam in four separate directions in the azimuth plane. Only three DC signals are required to control the seven PIN diodes attached along the spiral arm. The antenna has a 200-MHz-bandwidth around 3.3 GHz with

This paper presents an optimization circuit model of multiconductor transmission lines in the time domain. Several methods allow calculation of the currents and the tensions distributed on the uniform transmission line. Most of these methods are limited to lines with constant losses, and only for linear loads. The macro-model we propose, using Pade approximant, employs more variables and allows it

In this paper, four new wideband small antennas based on the composite right/left-handed transmission line (CRLH-TL) structures are designed, tooled, and made. The proposed antennas are introduced with best in size, bandwidth, and radiation patterns. The physical size and the operational frequency of the antennas depend on size of the unit cells and the equivalent transmission line model parameter

This paper presents power results of L-band packaged hybrid amplifiers using InAlN/GaN/SiC HEMT power dies. The high-power densities achieved both in pulsed and continuous wave (cw) modes confirm the interest of such technology for high-frequency, high-power, and high-temperature operation. We present here record RF power measurements for different versions of amplifiers. Up to 260 W, i.e. 3.6 W/m

This paper presents a method for automatic construction of stable and passive scalable macromodels for parameterized frequency responses. The method requires very little prior knowledge to build the scalable macromodels thereby considerably reducing the burden on the designers. The proposed method uses an efficient scattered sequential sampling strategy with as few expensive simulations as possibl

In this paper, a new multi-layered triple-passband bandpass filter using embedded and stub-loaded stepped impedance resonators (SIRs) is proposed. The filter is designed to have triple-passband at 1.8, 2.4, and 3.5 GHz. The 1st and 2nd passbands (1.8/2.4 GHz) are simultaneously generated by controlling the impedance and length ratios of the embedded SIRs (on top layer). The 3rd passband (3.5 GHz)

This paper presents a new concept for the fine tuning of high-Q bandpass filters to compensate for small response deviations due to manufacturing tolerances and temperature variations. Discrete frequency tuning steps are obtained using a rectangular waveguide resonator loaded with a reconfigurable E-plane circuit. Ohmic micro electromechanical systems (MEMS) switches can be placed along thin E-pla