The silicon vertical MOSFET RF power amplifier described in this paper is the industry?s first to utilize high-voltage vertical technology. Operating under pulse conditions of 200 µs pulse width and 10% duty cycle, it delivers more than 100 W of peak power. Operating in Class AB with only 50 mA of bias current the device achieves more than 20 dB of gain and 47% power added efficiency at P1dB compr

Low-cost enabling technologies for T/R modules (TRMs) in phased array radars are proposed and analyzed in terms of technology, performance, and cost aspects. Phase and amplitude controlling integrated circuits (ICs) realized in a low-cost standard silicon process are demonstrated. The design of several ICs at the S-, C-, on X-band has shown that silicon germanium is a strong contender for gallium

The use of 130-nm CMOS for power amplifiers at 20 GHz is explored through a set of power amplifiers as well as transistor level measurements. The power amplifiers explore single versus cascode configuration, smaller versus larger transistor sizes, and the combination of two amplifiers using power splitters/combiners. A maximum output power of 63 mW at 20 GHz was achieved. Transistor-level characte

A fast, yet unconditionally stable, solution of time-domain electric field integral equations (TD EFIE) pertinent to the scattering analysis of uniformly meshed and/or periodic conducting structures is introduced. A one-dimensional discrete fast Fourier transform (FFT)-based algorithm is proffered to expedite the calculation of the recursive spatial convolution products of the Toeplitz?block?Toepl

Metamaterial transmission lines can be realized as a combination of right- and left-handed transmission line (TL) sections exhibiting positive and negative dispersion. This approach gives additional degrees of freedom for improving the performance of microwave devices. Artificial right- and left-handed sections, which are based on lumped-element unit cells consisting of inductance and capacitances

An effective linearization technique capable of equalizing IM3 products resulting from an arbitrary out-of-band blocking scenario in a wideband direct conversion receiver is presented. IM3 products are regenerated in the RF analog domain of a low-power mixed-signal feedforward path and are used to cancel analogous signal terms in the original receiver at digital baseband via adaptive equalization.

This paper presents switched sequential amplifiers (SSAs) using reconfigurable directional couplers as power splitters and combiners. The SSA concept allows matching the efficiency characteristics to the amplitude probability density distribution of the applied modulated signal. Therefore the back-off efficiency can be increased significantly. A three-channel SSA can e.g. theoretically achieve a ?

The design of a subharmonic downconverter for 94-GHz imaging arrays in SiGe:C technology is presented. A three-stage differential low-noise amplifier (LNA) with lumped matching networks is used together with a subharmonic mixer driven by a single-pole local-oscillator poly-phase network to form the front-end. The LNA yields 15 dB gain at 94 GHz, while the mixer provides 5 dB conversion gain over a

Amplifiers for the next generation of T/R modules in future active array antennas are realized as monolithically integrated circuits (MMIC) on the basis of novel AlGaN/GaN (is a chemical material description) high electron mobility transistor (HEMT) structures. Both low-noise and power amplifiers are designed for X-band frequencies. The MMICs are designed, simulated, and fabricated using a novel v

In millimeter-wave CMOS circuits, a balun is useful for connecting off-chip single-end devices and on-chip differential circuits to improve noise immunity. However, an on-chip balun occupies a large chip area. To reduce the chip area required for the on-chip balun, a new rat-race balun using a rewiring technology with a wafer-level chip-size package (W-CSP) is proposed. The W-CSP balun occupies no

The rate of signal transmission on or between monolithic integrated circuits is limited by the cross-talk and the dispersion due to the wired interconnects. The bandwidth limitations can be overcome by wireless chip-to-chip and on-chip interconnects via integrated antennas. In this work the utilization of the electronic circuit ground planes as radiating elements for the integrated antennas has be

An L-band frequency and rejection-level tunable SiGe HBT differential amplifier with dual stopband is presented. To achieve frequency and rejection-level tunable performance, dual LCR-tank circuit with an active load is incorporated into the design of the series feedback loops of the differential amplifier. The active load consists of a varactor diode represented as a variable and a common-emitte

This paper presents a new planar particle that shows negative effective permittivity under irradiation by an electromagnetic wave. The mutual coupling between the couples of these particles is studied in particular. The response of this particle sensitive to an electric field is strongly anisotropic. The particle is aimed to be used to compose an isotropic epsilon-negative metamaterial in two form

In the framework of the Top Amplifier Research Groups in a European Team (TARGET) project, we developed a new electrical method for the temperature measurement of HEMTs and performed several unique studies on the self-heating effects in AlGaN/GaN HEMTs. This method, in combination with transient interferometric mapping (TIM), provides a fundamental understanding of the heat propagation in a transi

This paper presents a study of losses in substrate-integrated waveguides (SIWs) and cavities. Three mechanisms of losses are considered and separately investigated, namely radiation leakage, ohmic loss, and dielectric loss. A systematic comparison of waveguides with different geometry, operating at different frequencies, is reported. This study permits to give a physical interpretation of the loss

This article describes the design and performance of a compact tunable impedance transformer. The structure is based on a transmission line loaded by varactor diodes. Using only two pairs of diodes, the circuit is very small with a total length of only /10. Both the frequency range and the load impedance can be tuned by varying the varactor bias voltages. Our design provides a tunable operating fr

Traveling wave amplifiers (TWAs) offer the advantage of broadband amplification and a closed set of equations that allow deriving the RF gain by means of treating TWAs as discrete transmission line approximations. Up to now, however, the significant losses associated with CMOS integrated inductors have been neglected. This work presents a new approach for determining the transmission line losses a

This paper discusses on the miniaturization of radiofrequency (RF) front-end components such as half-wavelength resonators based on new magneto-dielectric heterostructures combining high permeability (µ = 150?250) and high permittivity (? = 18?150). Size reduction is evaluated by means of 2-cm-long coplanar waveguides realized with silicon technology and having a resonance frequency of about 3 GHz

A new model of two-access reconfigurable antennas for future mobile communication systems is presented in this article. This structure is based on a slot antenna with two separated access ports, isolated and matched at 1 and 2 GHz, respectively. The novelty of this element lies in the fact that first a filtering structure is integrated in the antenna, and then any additional switching or frequency

This paper deals with the various aspects of electromagnetic field impact modeling on the SiGe heterojunction bipolar transistor (HBT) device for microwave applications. This study differs from conventional HBT device reliability research associated with other stresses. The originality of this study comes from the generation of a localized electromagnetic field using the near-field bench. A coupli