In this paper, an amplitude shift keying (ASK) demodulator with 100% modulation depth is proposed. In order to achieve the higher power and wider reading range the designed ASK demodulator works in the ultra-high frequency. In this design, the average detector and voltage divider are used in order to define the appropriate threshold voltage level for the radio frequency input signal which leads to

A 10 × 10 ?m SiGe heterojunction bipolar photo-transistor (HPT) is fabricated using a commercial technological process of 80 GHz SiGe bipolar transistors (HBT). Its technology and structure are first briefly described. Its optimal opto-microwave dynamic performance is then analyzed versus voltage biasing conditions for opto-microwave continuous wave measurements. The optimal biasing points are the

In this paper, a new kind of admittance inverter and design of a switchable microstrip bandpass filter using composite right/left-handed (CRLH) cells has been presented. The proposed filter has two states (or passbands). One of the two passbands, is accessible at each time by on/off state of three PIN diodes. This filter is a three-pole, coupled resonator filter, composed of short-circuited shunt

The growing demand for communication systems requires multi-channel solutions. However, the number of antennas in communication systems is dictated by the number of channels in each system which is limited by the available space on a broadcasting platform and by the limited available resources. We have developed a Multi-Channel Phase Control coupler in the VHF frequency range enabling a reduction

An ultra-wideband (UWB) frequency-selective surface (FSS) exhibiting band rejection characteristic is presented in this paper. The proposed unit cell has the size of 14 × 14 mm which is approximately 0.18 × 0.18 ?, where ? corresponds to free space wavelength at the lower cut-off frequency. The proposed UWB FSS consists of a single-layer substrate and provides 20 dB attenuation level for a wide ba

A novel planar printed phase shifter design is proposed in this paper. The design is developed with microstrip?conductor-backed coplanar waveguide? microstrip (MP?CBCPW?MP) transition line with different defected ground structures (DGS). The differential phase shift can be controlled by altering the DGS dimensions. Three prototypes with DGS dimensions 5 × 10, 10 × 20, and 10 × 30 mm, are employed

In this manuscript, serial-shunt of square ring resonators with step-impedance open circuited stub resonators to produce a new on-off switchable bandpass to bandstop response in the same ultra-wideband microstrip filter structure is proposed. The closed ring of series-shunt square ring resonators with a combine stubs are introduced to excite the bandpass response while bandstop characteristic exci

A 0.18 µm CMOS Binary Frequency Shift Keying Modulator with a novel frequency synthesizer structure is proposed in this paper. Based on an analog adder technique being the backbone of the synthesizer, this prototype demonstrates a compact modulator with low complexity, which achieves 1 Mbps at 400 MHz while dissipating 3.1 mW at 1.5 V supply. The proposed design is ideal for biomedical sensor netw

This paper proposes an efficient and fast analysis of substrate integrated waveguide (SIW) components using a new approach of the iterative method called WCIP, i.e. ?Wave Concept Iterative Process?. This method is based on the iterative resolution of waves between two domains. The first is the spectral domain. We use the Floquet?Bloch decomposition to describe all modes in the spectral domain. The

A novel multiport system, allowing for measurements of scattering parameters in over-two-octave frequency range is proposed. It is composed of two directional couplers and a standard 4 × 4 Butler matrix, and does not require any isolators. The presented system features a uniform power distribution providing the high precision of measurements, which can be further enhanced by a simple adjustment of

In this paper, a novel design and experimental study of microstrip-line-fed rhombus-shaped slot antenna is presented. The proposed antenna shows an ultra-wide band (UWB) operation with good impedance matching by choosing appropriate rhombus-shaped slot and feeding structure. The proposed antenna has a simple structure and compact size as compared with many reported antennas. The measured results v

This paper presents the performance study of a 248 GHz voltage-controlled hetero-integrated signal source using indium phosphide (InP)-on-bipolar complementary metal-oxide-semiconductor (BiCMOS) technology. The source consists of a voltage controlled oscillator (VCO) in 0.25 µm BiCMOS technology and a frequency multiplier in 0.8 µm transferred-substrate InP-heterojunction bipolar transistor techno

In this paper, a wideband two-segmented four-element triangular dielectric resonator antenna (TDRA) with coaxial probe feed has been proposed. The proposed antenna has been analyzed, optimized, and studied through Ansoft HFSS simulation software. The prototype of the proposed antenna has been fabricated and its input characteristics are measured with the help of R&S Vector Network Analyzer. Good a

To restrict electromagnetic interference at WiMAX (3.3?3.7 GHz) and wireless local area network (WLAN) (5.15?5.825 GHz) bands operating within ultra wide bandwidth (UWB) band, a novel design of lamp-shaped UWB microstrip antenna with dual band-notched characteristics is presented. The proposed antenna is composed of a lamp-shaped radiating patch with two rectangular ground planes on both the sides

Fractals have unique properties such as self-similarity and space-filling. The use of fractal geometry in antenna design provides a good method for achieving the desired miniaturization, multi-band, and wideband properties. In this communication, novel fractal geometry is proposed based on which a multiband antenna is designed. The proposed antenna has fractal patches which are shaped as different

In this paper, a rectangular dielectric resonator antenna (DRA) with a parasitic gap-coupled microstrip resonator (MSR) is investigated; analytically, and experimentally. The proposed antenna uses an open-ended half-wavelength MSR patch as a hybrid radiator. Radiating modes are identified for both the radiators. Two separate and fully independent modes are merged together to get an enhanced bandwi

This paper presents the modeling, manufacturing, and testing of a micro-electromechanical system (MEMS)-based LC tank resonator suitable for low phase-noise voltage-controlled oscillators (VCOs). The device is based on a variable MEMS varactor in series with an inductive coplanar waveguide line. Two additional parallel stubs controlled by two ohmic MEMS switches have been introduced in order to in

In this report, a compact antenna system with dual-band-notched characteristics is proposed for ultra-wideband (UWB) multiple-input multiple-output (MIMO) applications. Two antenna elements are placed side by side and fed with matched microstrip lines on a substrate with an area of 35 × 30 mm. Notched characteristics at WiMAX (3.4?3.6 GHz) and WLAN (5.725?5.825 GHz) have been achieved using comple

A coplanar waveguide (CPW)-fed circular-shaped fractal antenna with third iterative orthogonal elliptical slot for ultra-wideband applications is presented. The bandwidth is enhanced by using successive iterations of radiating patch, CPW feedline, and tapered ground plane. An impedance bandwidth of 2.9?20.6 GHz is achieved. The designed antenna has omnidirectional radiation patterns along with ave

Wideband dipole antennas are proposed using the multi-mode resonance concept. By symmetrically introducing one-pair or two-pair of stubs at the nulls of current distribution of the second odd-order mode, two radiation modes are excited in a single, center-fed dipole resonator. Using these stubs, the second odd-order mode gradually moves down to its first counterpart, resulting to achieve a wideban

A simple and compact printed ultra-wideband antenna with dual-band-notched characteristics is presented. The proposed antenna is composed of a rectangular patch and a modified ground plane. The rectangular patch is etched onto a lossy FR4 substrate. A circular ring strip parasitizes the rectangular patch embedded by a U-shaped slot. Two inverted-L slits and a rectangular slit are embedded onto the

This paper describes a new configuration of frequency-selective structure (FSS) structures to reduce mutual coupling between the radiating elements. Also, the antenna performance before and after the implementation of FSS have been investigated. The proposed configuration provides an improvement in mutual coupling by 14 dB (measured value) with a reduced edge-to-edge spacing of 23 mm. The reductio

Patch antennas with a meandering slot and different distributions of grounded metallic vias are presented in this paper. The meandering slot is adopted to stimulate dual-band operation, while the number and position of the grounded metallic vias are suggested to achieve different radiation performances. The characteristics are analyzed in detail where we find that the existence of the vias also im

A coplanar waveguide-fed planar hexagonal monopole ultra-wideband antenna with dual-band rejection characteristics is proposed in this paper. The desired notch frequencies at 3.5 and 5.5 GHz are realized by incorporating mushroom structures. The input impedance and surface current distributions are used for analysis and explanation of the effects of mushroom cells. The prototype and proposed anten

This paper of lettering reveals about a modified Koch snowflake fractal multiband antenna for cognitive radio applications. Multiband antennas can be employed for spectrum sensing in cognitive radio. This new microstrip-modified Koch fractal antenna exhibits multiple actions in four dissimilar resonant frequencies at 3.2, 5.2, 6, and 9.5 GHz correspondingly that covers the frequency bands such as