A microstrip transmission line fed fork-shaped planar antenna is proposed for Bluetooth, WLAN, and WiMAX applications. The antenna made of a microstrip feed line, fork-shape patch on one side and defected ground plane on the other side of dielectric substrate. A fork-shape is formed by two side circular arms and a rectangular central arm. The inverted T-shaped ground plane with a rectangular slot

This paper presents the behavior of three iterations of a coplanar waveguide fed CANTOR Set fractal antenna. This kind of antennas allows having a broadband behavior and important gains. Also, the setup of slots allows having more lower resonant frequencies and therefore designing miniaturized antennas with good performances. The proposed antennas are suitable for 2.5/3.3/5/5.5 GHz worldwide inter

The design and measurement of reconfigurable circularly polarized capacitive fed microstrip antenna are presented. Small isosceles right angle triangular sections are removed from diagonally opposite corners for the generation of circular polarization (CP) of axial ratio bandwidth of 11.1%. Horizontal slits of different lengths are inserted at the edges of the truncated patch to provide the dual-b

A new Ku-band reflectarray with an artificial anisotropic slab that consists of periodic holes, backed by a planar artificial magnetic conductor (AMC) is proposed. The unit-cell of the reflectarray is a two-layered structure that consists of a dielectric with a hole on a grounded patch. The phase diagram of the proposed unit-cell is calculated by a full-wave computational technique, which uses the

A new design of reconfigurable sub-nanosecond pulse generator (PG) with pulse shape selection ability is presented in this paper. Step recovery diode is used as the pulse sharpening device and the pulse shaping circuit consists of a controllable RC differentiator in which a single PIN diode is embedded, which provides two different switchable pulse shaping performances. The realized PG has a compa

A novel small embedded long-term evolution/wireless wide area network (LTE/WWAN) antenna integrated with the keyboard ground plane in a laptop computer is presented. The antenna is installed on a notched region (40 × 8 mm) of the keyboard ground plane at a distance of 10 mm from the laptop computer hinge. A coupled-fed loop antenna was used because of its suitability for integration with the groun

A circular patch antenna with wide impedance bandwidth and monopolar radiation pattern for indoor wireless communication is proposed and analyzed in this paper. The antenna is a combination of circular patch and four capacitive feeds. By incorporating a cross-connected shorted conducting strip over the circular patch, the proposed antenna provides an enhanced impedance width of 65.4%, ranging from

This paper presents a wideband band-stop filter (BSF) structure designed by using planar technology. The proposed filter consists of a modified conventional band-stop structure with open stubs, inner T-inverted shape, and two input/output feed lines. Based on series of optimization and a specific design method, two compact filters with good electrical performance are obtained. In order to characte

A novel radio frequency identification tag antenna is composed of a resonant open-slot exciter and a dipole-type ground radiator. For a conjugate match to the Alien Higgs-4 chip impedance of 8?j149 ? at 925 MHz, a quarter wavelength open-slot resonator embedded at the center of the dipole-type ground plane (130 × 18 mm) was investigated and fabricated. Simple size adjustments and various loaded in

In this study, we design a differential CMOS power amplifier using a 180-nm SOI RFCMOS process for 802.11n (64-QAM, 20 MHz bandwidth, 9.6 dB peak to average power ratio (PAPR)) applications. To minimize the chip area and mismatch in differential signals, we propose a layout method with an inter-stage matching network using a split inductor. By virtue of the symmetrical layout of the proposed split

Fresnel Zone Plate lens (FZPL) antennas working in the V and W band are reported in this paper with half and quarter phase correction respectively. A low cost and straightforward technological process is used to manufacture the dielectric lenses using only one foam material where the dielectric constant is controlled. Simulation and measurement results are in good agreement that confirms the viabi

In this paper, we demonstrate the successful implementation of an onwafer noise parameters test set that employs an extended six-port network and a conventional noise figure analyzer. The necessary formulation that enables the calibration of the noise parameter test set as well as extraction of the noise wave correlation matrix of a two-port device under test (DUT) was tested for coaxial connector

An ultra-wideband (UWB) log-periodic dipole array (LPDA) antenna inkjet-printed on a 0.5 mm thick photo paper substrate is presented. The overall size of the LPDA antenna is 130 × 60 mm. The LPDA antenna exhibits stable input-impedance characteristics and a consistent end-fire radiation pattern over the whole operating band of 2.2?11 GHz. Fulfilling the need of high-gain flexible antennas for UWB,

We review the main results of the development of whispering gallery mode (WGM) resonators and their unique applications due to their quasi-optical functionality. Several types of advanced WGM resonators are proposed by the authors. The theoretical results are described for the resonators with an analytical solution of the electromagnetic problems. Special emphasis is given to the interaction of mo

A new planar microstrip-fed monopole ultra-wideband (UWB) antenna with dual notched bands has been presented. By employing a simple dual-mode resonator with two symmetrical outer high-impedance lines beside the microstrip feed line of the proposed UWB antenna, two controllable rejection bands with high-frequency selectivity are created. The parametric studies of the proposed structure are explored

This paper proposes a novel wideband to concurrent tri-band frequency reconfigurable microstrip antenna. The frequency reconfiguration is achieved by using a pair of PIN diodes in the antenna feed line to switch the antenna either in wideband mode or in concurrent tri-band mode. In order to improve the bandwidth and gain of the antenna for wideband operation, the properties of J-K inverter and spl

In this paper, we propose a double balanced mixer with a tunable Marchand balun. The circuit is designed in a SiGe BiCMOS process using Schottky diodes. The tunability of the Marchand balun is used to enhance critical parameters for double balanced mixers. The local oscillator-IF isolation can be changed from ?51 to ?60.5 dB by tuning. Similarly, the IIP can be improved from 41.3 to 48.7 dBm at 11

This paper presents application of split ring resonators (SRR) in conventional waveguide slot array antenna to achieve performance improvement and multiband characteristics. Three SRRs have been placed on the transverse plane of a conventional slotted waveguide and has been simulated and measured. The measured results show that the antenna has dual band response with respective 10 dB return loss b

Specifications of the substrates are among the most important and problematic parameters that still do not have proper models in the design procedures of metasurfaces. In this paper, a new fast and exact algorithm based on artificial neural networks (ANNs) is presented, which makes it possible to design frequency-selective surfaces (FSSs) on various kinds of standard substrates. Also for the first

In this paper, an X-shaped fractal antenna with defected ground structure (DGS) is presented for multiband and wideband applications. The X shape is used due to its simple design and DGS is utilized to achieve size reduction with multiband and wideband features in the frequency range of 1?7 GHz. The proposed structure is fabricated on FR4 substrate with 1.6 mm thickness. We have proposed two diffe

In this paper, the structure of a common field-effect transistor (FET)-based negative impedance converter (NIC) that behaves as a negative capacitor is presented. The nonlinear modeling, analysis, and simulation of this non-Foster structure are presented in the time domain and the transient response of the circuit can be used to study the stability of the circuit. For the analysis of the circuit p