We propose in this paper a 4-channel time-domain test bench for the characterization and linearity enhancement of microwave power amplifiers (PAs). The proposed time-domain measurement system utilizes four track and hold amplifiers (THAs) for direct subsampling of radiofrequency (RF) signals. The use of wideband THAs to replace samplers or mixers enables reducing analog IF circuit complexity. It p

The design of a high-stability radiometer is presented in this paper. It is used to characterize the stability of a microwave active cold load at L-band. The two-load radiometer takes advantage of a noise injection technique to improve its sensitivity. A temperature-stabilized enclosure is used to minimize gain and noise temperature fluctuations of the receiver. The radiometer sensitivity is 0.031

A new design method for multi-access antennas is presented. This method is based on a modal analysis assuming the microstrip antennas as a resonant cavity. Using this cavity approach, the eigenmodes perturbation induced by the cavity deformation (adding slots or short circuits) is studied. As an application, a solution of multi-access antenna with two ports, with operating frequency bands centered

In designing a Foreign Object Debris (FOD) detection system on airport runways, this paper deals with the performance of a 77 GHz reflectarray antenna (RA). Debris may be very small and have low radar cross section (RCS), leading to design a high gain primary-fed offset RA. To minimize the aperture blockage, the main radiation lobe is in the specular direction. The antenna has a maximum gain of 40

The paper outlines an exhaustive computer-aided design (CAD) procedure for the circuit-level simulation of entire multi-input multi-output (MIMO) links. The multiple transmitting and receiving antennas are treated as multiport radiating systems characterized by electromagnetic (EM) analysis. The effects of mutual couplings in terms of the frequency-dependent near-field and far-field performance of

A novel topology for millimeter-wave-integrated transformers is proposed. The windings are stacked and secondaries are designed with different trace widths and different diameters from that of the primary, in order to obtain relatively high-inductance transformation ratios. Measurement and simulation results of 65 nm Complementary Metal Oxide Semiconductor (CMOS) and 130 nm combination of Bipolar

LInear amplification using Non-linear Components (LINC) is an architecture that achieves linear power amplification for radio-frequency (RF) transmitters. This paper describes the impact of RF power amplifiers (PAs) class on the overall system performances. The linearity and efficiency of the LINC transmitter with different PA classes (AB, B, C, D, E, F, F, and J) are evaluated and compared, in te

The possibility to characterize infinite and periodic frequency-selective surfaces (FSS) filters that have two orthogonal axes of symmetry inside a waveguide is reported. Thus, preliminary measurements can rapidly be obtained at low cost with few elementary cells instead of using a large FSS panel in free space. This is possible because of the equivalence that exists between the electromagnetic fi

This paper presents an analysis of totem-pole (TP) stages for driver applications and summarizes the major design constraints for an optimization with respect to P1dB, OIP3, and bandwidth. It is shown, that for matched drivers, in contrast to the widely applied common collector (CC) stage, class-AB TP stages offer higher output power and much higher power-added efficiencies (PAE) at comparable ban

In this paper characterization of dielectric materials in liquid and powder phase using concentric closed and split ring resonators of length ?, ?/, and ?/ is reported. Experimental results have been validated by simulations and theoretically modeling. Sensitivity of the resonator with closed rings was maximum. Experimentally extracted values of dielectric constant of ferrite ranged from 14.05 to